Dell PowerVault NX3000 - Manual (Page 14)

Cannot Install SIS On A Volume Without A Mount Point
Description If you install SIS on a volume without a mount point, such as a drive letter or folder mount point, the
operation fails while incorrectly displaying a message similar to the following:
SIS has been initialized on volume '\\?\Volume{f2eb8ac
f-0ad7-49b3-bd92- b93ce5680c85}\'. Restarting the Groveler
service...
Workaround/
Solution To workaround this issue, assign a valid mount point to the volume before enabling SIS for the
volume.
Groveler Service May Not Recognize A Volume After Changing The
Drive Letter
Description SIS requires that all volumes using SIS must be assigned either a drive letter or a folder mount
point. If you use disk management to change the mount point or drive letter of a SIS volume, the
Groveler service may fail to recognize the new configuration immediately. The Groveler service
adapts to the change within an hour and restores full functionality.
Workaround/
Solution To correct the issue, type sisadmin.exe /I at the command prompt.
Turning Off The Firewall
Description To turn off the firewall follow the steps given below.
Workaround/Solution
1. Launch Server Manager and navigate to the Configuration snap-in.
2. Expand the snap-in and right-click Windows Firewall with Advance Security.
3. Select Properties and turn off the required firewall.
14