Supported raid controller firmware and nvsram, Supported iscsi software initiators – Dell PowerVault MD3820f User Manual
Page 11

11
Default IPv4 settings for the iSCSI Ports on MD38x0i
array
NOTE: No default gateway is set.
By default, the iSCSI ports on the storage array are set to the following static IPv4 settings:
Table 6. Default iSCSI Port IPv4 Addresses on MD38x0i Storage Arrays
Controller/Port (MD38x0i)
IPv4 address
Subnet Mask
Port #
Controller 0, Port 0
192.168.130.101
255.255.255.0
3260
Controller 0, Port 1
192.168.131.101
255.255.255.0
3260
Controller 1, Port 0
192.168.130.102
255.255.255.0
3260
Controller 1, Port 1
192.168.131.102
255.255.255.0
3260
Supported RAID Controller Firmware and NVSRAM
NOTE: It is advisable to gather support information before performing any
firmware upgrade.
NOTE:
Only drivers and firmware released by Dell are supported. For the latest
driver and firmware releases, see the Downloads section at
support.dell.com.
Table 7. Latest RAID Controller Firmware and NVSRAM Versions
Software
Version
RAID Controller
Firmware
08.20.05.60
RAID Controller
NVSRAM
N2701-820890-004
Supported iSCSI Software Initiators
Table 8. Supported iSCSI Initiators
Operating System
SW Initiator Vendor
SW Initiator Version
Notes
Windows Server OS
Microsoft
RTM or later
Included w/OS
Red Hat Enterprise Linux
Red Hat
RTM or later
Included w/OS
SUSE Linux Enterprise Server SUSE
RTM or later
Included w/OS
VMware ESX
VMware
RTM or later
Included w/OS