Dell OptiPlex GX1 - Manual (Page 25)

Removing and Replacing Parts: Dell OptiPlex GX1 Systems Service Manual
file:///C|/infodev/2013/eDoc/OpGX1/SM/remsff.htm[2/21/2013 11:45:32 AM]
to Not Detected.
See the User's Guide for detailed information on the chassis intrusion detector.
NOTE: If a setup password has been assigned by someone else, contact your network administrator
for information on resetting the chassis intrusion detector.
DIMMs
Figure 26. DIMM Removal
1 Ejectors (2)
CAUTION: Use a wrist grounding strap as explained in " Precautionary Measures ."
To remove a DIMM, perform the following steps:
1. Push outward on the two DIMM socket ejectors simultaneously until the DIMM is released from its
socket.
2. Lift the DIMM away from the socket.
To install a DIMM, press the DIMM fully into the socket while closing the ejectors to lock the DIMM into the
socket (see Figure 27).
Figure 27. DIMM Installation
1 Ejectors (2)
2 Notches (2)