Display bezel, Replacing the display assembly, Removing the display bezel – Dell Inspiron 14 (N4030, Mid 2010) User Manual
Page 18
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.
3.
Connect the display cable to the connector on the system board.
4.
Route the antenna cables through the routing guides and connect the cables to the Mini-Card (see
Replacing the Mini-Card
).
5.
Replace the palm rest (see
Replacing the Palm Rest
).
6.
Replace the keyboard (see
Replacing the Keyboard
).
7.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
8.
Replace the module cover (see
Replacing the Module Cover
).
9.
Follow the instructions from
step 3
to
step 4
in
Replacing the Optical Drive
.
10.
Follow the instructions from
step 4
to
step 5
in
Replacing the Hard Drive
.
11.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
).
3.
Make a note of the Mini-Card antenna cables and the display cable routing on the display hinges.
4.
Using your fingertips, carefully pry up the inside edge of the display bezel.
5.
Remove the display bezel.
1 display assembly
2 screws (2)
3 Mini-Card antenna
cables
4 display cable
connector
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.