Dell Latitude D810 - Manual (Page 51)

Back to Contents Page
Video Card Assembly
Dell™ Latitude™ D810 Service Manual
Removing the Video Card Assembly
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the display assembly .
3. Remove the keyboard .
4. Remove the palm rest .
5. Loosen the four M2.5 corner screws (marked with a triangle on the thermal-cooling assembly) from the video card assembly. These screws connect the
video-card thermal-cooling assembly to the system board.
6. Lift the video card assembly straight up and out of the computer.
Back to Contents Page
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
1 M2.5 x 5-mm corner
screws
2 video card assembly