beautypg.com

Replacing the system board – Dell XPS 730 H2C (Late 2008) User Manual

Page 39

background image

Back to Contents Page

 

Replacing the System Board

Dell™ XPS™ 730/730X Service Manual 


 

 

1.

Follow the procedures in

Before You Begin

.


 

2.

Remove the computer cover (see

Replacing the Computer Cover

).


 

3.

Remove any full-length expansion cards (see

Replacing the PCI and PCI Express Cards

).


 

4.

Remove any additional components that may restrict access to the system board.

 

5.

Disconnect all cables from the system board.

 

 

6.

Remove the two screws securing the system board assembly to the chassis, then pull on the two tabs to slide the system board assembly towards the
front of the computer.

 

 

7.

Carefully, lift the system board assembly up and out of the computer.

 

 

8.

Transfer components from the existing system board to the replacement system board, if applicable.

 

9.

Orient the system board assembly by aligning the notches on the bottom of the assembly with the tabs on the computer.

 

10.

Slide the system board assembly toward the back of the computer until the assembly clicks into place.

 

11.

Replace the two screws to secure the system board assembly to the chassis.

 

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance

CAUTION:

If you are replacing the system board, visually compare the replacement system board to the existing system board to make sure that

you have the correct part.

1

screws (2)

2

system board

3

metal tray

4

tabs

CAUTION:

The system board and metal tray are connected and are removed as one piece.

CAUTION:

If you are replacing the system board, visually compare the replacement system board to the existing system board to make sure that

you have the correct part.

NOTE:

Some components and connectors on replacement system boards may be in different locations than corresponding connectors on the existing

system board.

NOTE:

Jumper settings on replacement system boards are preset by the factory.

This manual is related to the following products: