Post os-upgrade steps – Dell Powervault DL2300 User Manual
Page 9
Upgrading from Windows Server 2008 x64 to Windows Server 2008 R2 for
CommVault™ Simpana™
Page 7
Figure 7: Upgrade vs Custom Install
Post OS-Upgrade Steps
The following section describes the steps that you must run once the upgrade to Windows Server 2008
R2 is complete and before the DL Backup to Disk Appliance is ready to be used.
1. Download the Recovery and Update Utility (RUU) for your platform to a folder on the C:\ drive
from
http://support.dell.com/support/downloads/
Depending on the hardware platform, the
appropriate RUU can be downloaded by following the steps below.
a. If you are performing the OS upgrade on a DL2000, Windows Server 2008 x64 is the only
OS available in the Operating System drop-down list. Select the RUU download
available under the IDM dropdown.
b. If you are performing the OS upgrade on a DL2100, Windows Server 2008 x64 is the only
OS available in the Operating System drop-down list. There are two RUU downloads
under the IDM drop-down. Make sure you select the RUU download for Windows
Server 2008 R2.