Hinge cover, Removing the hinge cover, Replacing the hinge cover – Dell Inspiron 9400 User Manual
Page 33
Back to Contents Page
Hinge Cover
Dell™ Inspiron™ 9400 Service Manual
Removing the Hinge Cover
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Open the display all the way (180 degrees) so that it lies flat against your work surface.
3.
Using a small plastic scribe, insert the scribe on the right side to gently pry the hinge cover loose.
4.
Pulling up from right to left, remove the hinge cover.
Replacing the Hinge Cover
With the display open all the way (180 degrees) so that it lies flat against the work surface, snap the cover back into place, starting from left to right.
Back to Contents Page
CAUTION:
Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
NOTICE:
The hinge cover is fragile and can be damaged if extreme force is used. Be careful when removing the hinge cover.
NOTICE:
To help avoid damage to the hinge cover, ensure that it is snapped securely into place before you rotate the display open to 180 degrees.
1
hinge cover