Dell Inspiron 13 7000 Series 2-in-1(7348, Early 2015) - Manual (Page 89)

Removing the Display Cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover .
2 Remove the battery .
3 Remove the display assembly .
4 Remove the display back-cover and antenna assembly .
5 Remove the camera .
Procedure
1 Peel off the adhesive tape and lift the latch to disconnect the display
cable from the display panel.
2 Disconnect the Windows-button board cable.
3 Peel off the adhesive tape, lift the connector latch to disconnect the
touch-screen board cable from the touch-screen board.
4 Remove the camera cable from the routing guides on the display bezel.
5 Lift the connector latch and disconnect the display cable from the touch
board.
6 Note the display cable routing and remove the display cable from the
routing guides on the display bezel.
89