Power button board, Removing the power button board, Replacing the power button board – Dell Inspiron Mini 10v (1011, Mid 2009) User Manual
Page 34
Back to Contents Page
Power Button Board
Dell™ Inspiron™ 1011 Service Manual
Removing the Power Button Board
Replacing the Power Button Board
Removing the Power Button Board
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the palm rest (see
Removing the Palm Rest
).
5.
Remove the hard drive (see
Removing the Hard Drive
).
6.
Remove the palm rest bracket (see
Removing the Palm Rest Bracket
).
7.
Turn the palm rest bracket over and remove the screw that secures the power button board to the palm rest bracket.
8.
Remove the power button cable from its routing.
9.
Slide the power button board out of the palm rest bracket.
Replacing the Power Button Board
1.
Slide the power button board to its place on the palm rest bracket.
2.
Replace the screw that secures the power button board to the palm rest bracket.
3.
Route the power button cable through its routing guide.
4.
Replace the palm rest bracket (see
Replacing the Palm Rest Bracket
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
screw
2
power button board