Dell XPS 11 (9P33, Late 2013) - Manual (Page 23)

Replacing the Display Assembly | 23
Replacing the Display Assembly
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before Working Inside
Your Computer" on page 5. After working inside your computer, follow the
instructions in "After Working Inside Your Computer" on page 7.
For more safety best practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the display hinges with the screw holes on the
palm-rest assembly.
2 Replace the screws that secure the display hinges to the palm-rest assembly.
3 Slide the webcam cable into the system-board connector and press down on the
connector latch to secure the cable.
4 Connect the display cable to the system board.
5 Connect the antenna cables to the wireless card.
6 Adhere the conductive and Mylar tapes to the antenna cables.
7 Turn the computer over.
8 Rotate the palm-rest assembly to an angle of 180 degrees.
Postrequisites
1 Replace the battery. See "Replacing the Battery" on page 12.
2 Replace the base cover. See "Replacing the Base Cover" on page 10.