Dell PowerVault DL2000 - Manual (Page 2)

7 Power on the system components.
Information in this document is subject to change without notice.
© 2008 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without
the written permission of Dell Inc. is strictly forbidden.
Dell, PowerVault, PowerEdge, and the DELL logo are trademarks of
Dell Inc. Microsoft, Windows, and Windows Server are either
trademarks or registered trademarks of Microsoft Corporation in the
United States and/or other countries; Symantec, the Symantec logo,
and Backup Exec are trademarks or registered trademarks of
Symantec Corporation or its affiliates in the U.S. and other countries.
Dell disclaims proprietary interest in the marks and names of others.
September 2008
Printed in the U.S.A. w w w . d e l l . c o m | s u p p o r t . d e l l . c o m
0X641HA01
9 Using the DL Backup to Disk Appliance. 10 Advanced backup operations, keeping software up to date, and finding help.
8 Enter the default password to log into Windows and configure the DL Backup to Disk Appliance.
Turn on components in the following order:
1. MD1000 expansion enclosure(s)
2. DL2000 system and monitor
You’ve Installed the Hardware. What’s next ?
When the system is powered on for the first time, you are prompted for a Windows password. This default password is:
Stor@ge!
Enter this password to log on to your system for the first time. The Dell PowerVault DL Backup to Disk Appliance Configuration Wizard will
automatically launch. Click N
Ne exxtt to begin installing the Symantec Backup Exec software.
Advanced Backup Operations
For information on advanced planning, creating and scheduling backup jobs, managing backup to disk folders, customizing backup
options, implementing policies and templates, setting up alerts and notifications, viewing reports, and disaster preparation and
recovery, see the
Symantec Backup Exec 12.5 for Windows Servers Administrator’s Guide .
Important Updates
For the latest operating system updates, go to u up pd da atte e..m miic crro osso offtt..c co om m.
The Dell Backup to Disk Appliance Application Recovery and Update Utility at ssu up pp po orrtt..d de ellll..c co om m can be used to reinstall or update Dell
software.
If You Need Help
• A complete list of solution documents is contained in the Dell Backup to Disk Appliance - Powered by Symantec Backup Exec
Quick Reference Guide at ssu up pp po orrtt..d de ellll..c co om m//m ma an nu ua allss.
• For hardware issues, refer to the PowerVault documentation set that shipped with your
system. These documents are also available at ssu up pp po orrtt..d de ellll..c co om m//m ma an nu ua allss.
Locating Your System Service Tag
• When you contact technical support, the Express Service Code helps route your call to the
appropriate support area and the Service Tag number helps identify your system.
• In the figure, the location of the Service Tag number and Express Service Code is shown.
Write down this information and store it in a safe place.
Using the DL Backup to Disk Appliance
After the Dell PowerVault DL Backup to Disk Appliance
Management Console automatically launches, click LLa
au un nc ch h
S Syym ma an ntte ec c B Ba ac ckku up p E Exxe ec c (right).
Once the Symantec Backup Exec software (left) launches, Backup
Exec Assistant (H
He ellp p →BBEE AAssssiissttaanntt) can help you:
• Create a backup job
• Install remote agents and media servers
• Perform advanced configuration
• Find references to user documentation
X641Ham1.qxd 10/14/2008 9:08 PM Page 2