Tweeters, Removing the tweeters, Replacing the tweeters – Dell Studio 1440 (Mid 2009) User Manual
Page 52
Back to Contents Page
Tweeters
Dell™ Studio 14z Service Manual
Removing the Tweeters
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the hard drive (see
Removing the Hard Drive
).
5.
Remove the palm rest (see
Removing the Palm Rest
).
6.
Remove the display assembly (see
Removing the Display Assembly
).
7.
Remove the two screws (one on each tweeter) that secure the tweeter frames to the system board.
8.
Replace the hard drive (see
Replacing the Hard Drive
).
9.
Remove the tweeter cables from their connectors on the system board.
10.
Remove the tweeter frames containing the tweeters.
Replacing the Tweeters
1.
Follow the procedures in
Before You Begin
.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
1
screws (2)
2
tweeter connectors (2)
3
tweeter cables (2)
4
tweeter frames (1 left, 1 right)
5
tweeters (2 total; one on each frame)