Dell Studio 1440 (Mid 2009) - Manual (Page 34)

Replacing the Memory Module
1. Follow the procedures in Before You Begin .
2. Align the notch in the memory module edge connector with the tab in the memory module connector slot.
3. Slide the module firmly into the slot at a 45-degree angle, and press the module down until it clicks into place. If you do not hear the click, remove the
module and reinstall it.
4. Replace the memory module cover.
5. Replace the battery (see Replacing the Battery ), or connect the AC adapter to your computer and an electrical outlet.
6. Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.
To confirm the amount of memory installed in the computer, click Start ® Help and Support® Dell System Information.
Back to Contents Page
1 memory module connector 2 memory module
3 securing clips (2)
NOTE: If the memory module is not installed properly, the computer may not boot.
1 tab 2 notch
3 memory module edge connector
CAUTION: If the memory module cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your
computer.