Dell PowerVault 50F (Fibre Channel Switch) - Manual (Page 43)

PowerVault™ 50F Commands: Dell™ PowerVault™ 50F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
file:///C|/Users/sharon_anand/Desktop/PowerVault/50f_enit/COMMANDS.HTM[3/15/2013 11:32:02 AM]
Back to Contents Page
PowerVault™ 50F Commands: Dell™ PowerVault™ 50F 8-Port
Fibre Channel Switch Installation and Troubleshooting Guide
Overview • General Commands • Diagnostic Commands • Routing (Show) Commands
Overview
This chapter contains information and examples on managing and monitoring the switch via Telnet,
including:
General Commands
Diagnostic Commands
The user can configure, operate, and test the switch using the following commands and settings through the
Telnet interface.
General Commands
The following general commands allow you to control basic switch operations.
agtcfgSet
Figure 7-1 shows the agtcfgSet command which is used to set the Simple Network Management Protocol
(SNMP) manage node configuration to a fiber channel switch. The fields are described in Table 7-1.
Figure 7-1. agtcfgSet Command Example