Dell KVM 2162DS - Manual (Page 23)

2
Installation xxx | xxx 13
Installation
The RCS transmits KVM and serial information between operators and target
devices connected to the switch over a network using either an Ethernet or
modem connection. The RCS uses TCP/IP for communication over Ethernet.
For the best system performance, use a dedicated, switched 100BaseT or
1000BaseT network. You can also use 10BaseT Ethernet.
The RCS uses the Point-to-Point Protocol (PPP) for communication over a
V.34, V.90, or V.92 modem. You can perform KVM and serial switching tasks by
using the OBWI or the Avocent management software. For more information on
the Avocent management software, visit http://www.avocent.com.
The RCS box includes the RCS, RCS software, and the OBWI. You may choose
to use either the RCS software or the OBWI to manage your system. The
OBWI manages a single RCS and its connections, while the RCS software can
manage multiple switches and their connections. If you plan to use only the
OBWI, you do not need to install the RCS software.
NOTE: The RCS software can be used to manage some switches. For more
information, please refer to the appropriate installer/user guide for your
product.
NOTE: Please ensure that all your RCSs have been upgraded to their most
recent version of Firmware. For information on upgrading an RCS through the
OBWI, refer to "RCS Tools" on page 52.
RCS Quick Setup
The following is a quick setup list. To begin by mounting the RCS in a rack and
for detailed installation instructions, see "Getting Started" on page 15.