Dell Inspiron 23 (5348, Early 2014) - Manual (Page 97)

Removing the Antenna
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the stand assembly .
2 Remove the back cover .
3 Remove the memory module(s) .
4 Remove the system-board shield .
5 Remove the hard drive .
6 Remove the VESA-mount bracket .
7 Remove the control-buttons board .
8 Remove the converter board .
9 Remove the power-supply diagnostic board .
10 Remove the I/O bracket .
11 Remove the optical drive .
12 Remove the power-supply fan .
13 Remove the power-supply unit .
14 Remove the processor heat sink .
15 Remove the processor fan .
16 Remove the processor .
17 Remove the wireless card .
18 Remove the coin-cell battery .
19 Remove the system board .
Procedure
1 Peel the tape that secures the antenna modules to the display bezel.
2 Remove the screws that secure the antenna modules to the display bezel.
3 Note the antenna-cable routing and remove the antenna cables from the
routing guides on the display-panel base.
97