Combi 8100 - Manual (Page 19)

Storage Of Lower Anchor Belt And Connectors:
When not using the LATCH System, store the
lower anchor belt and connectors by snapping
the connectors onto LATCH connector storage
rings located on the back side of the
seat pad (fig. l). Pull on free end of
lower anchor belt to tighten.
NOTE: To prevent damage to the seat
pad, care should be taken when
removing or securing connectors.
Excessive force could damage
or tear seat pad.
35
(fig. l)
LATCH
Connector
Storage Ring
36
WARNING
DEATH or SERIOUS INJURY can occur
• Not all vehicle seat belts can be used with this car seat. Read
vehicle owner’s manual and “Vehicle Seat Belts” section in this
manual.
• Vehicle seat belt MUST stay tightly adjusted around car seat at
all times. If vehicle seat belt does not stay tight, read the
vehicle owner’s manual and “Vehicle Seat Belts” section in this
manual.
Refer to vehicle owner’s manual to identify the
seating locations which can be used with a car seat.
Check for specific instructions for car seat use.
After selecting a seating location, if adjustable,
adjust vehicle seat back into most upright position.
Rotate car seat on lower base to forward-facing
position, see “Changing Forward-Facing/
Rear-Facing Use Position” section.
Place car seat forward-facing in the vehicle seat
location selected with forward-facing belt path
openings toward vehicle seat back (fig. a).
2
3
1
4
(fig. a)
Section 9b - Forward-facing Installation
With Vehicle Seat Belt
Forward-facing
Belt Path