Combi 8100 - Manual (Page 15)

28
(fig. h)
Check for secure installation. Gripping car seat
at top of armrest, pull car seat front to back and
left to right to check for secure installation (fig. h).
Vehicle lap belt MUST stay tight.
- If the vehicle lap belt does not stay tight
or car seat can not be securely installed,
see vehicle owner’s manual, “Vehicle Seat
Belts” section or move to a different seating
location.
Recheck recline of car seat. Adjust if necessary
(see step 11).
12
13
Removal Of Car Seat Installed With Vehicle Seat Belt:
Unbuckle vehicle seat belt.
- Pressing down in center of car seat to reduce
tension on vehicle seat belt will make it easier
to loosen vehicle seat belt.
Open belt lock-off and remove vehicle seat belt
from belt path.
1
2
Tighten vehicle seat belt to secure the
car seat.
- Press down in center of car seat
to depress the vehicle cushion while
tightening vehicle seat belt (fig. e).
Close belt lock-off over lap or lap and
shoulder belt (fig. f).
To close:
- Push down lock-off cover .
- Then push down locking tab .
Check recline of car seat. Line inside
level indicator MUST be in green striped
zone (fig. b). If line is not in green
striped zone, adjust recline position or
place tightly rolled up towel, blanket or
firm foam (pool noodle) under end of
car seat contacting vehicle seat back (fig. g).
If car seat can not be adjusted to locate
the line in the green striped zone:
1. Try a different seating position.
2. Do not use this car seat.
NOTE: Vehicle must be parked on
horizontal surface and child in
car seat when checking angle
of car seat.
27
(fig. f)
(fig. e)
9
Towel or
Pool Noodle
(fig. g)
2
1
1 2
11
10