Compaq MP4800 - Manual (Page 33)

Using the On-Screen Display Menu
Compaq iPAQ Microportable Projector MP4800 User’s Guide 3–9
■ Language—Allows you to change the on-screen display to
one of the languages in their native spelling. The current
language is highlighted. Select another language to display
all menu functions in that language.
■ Management—Allows you to control lamp saver
characteristics of the display, view the cumulative lamp
hours, or set the OSD horizontal and vertical position,
timeout, and transparency.
✎
By default, the OSD menu is on top of the displayed image.
Selecting OSD Transparency from the Management menu
allows you to adjust this setting so the displayed image can be
seen behind the OSD menu. Changes can be seen as they are
being made.
■ A/V & HDTV Control—Allows you to stretch the format to
fill the screen or to use the original aspect ratio and fill the
screen, using HDTV (High Definition Television) format.
Refer to the “HDTV Modes” section of Chapter 6 for more
information. Also allows color space selection, audio
preference selection, and Gamma adjustment.
■ Input Source Select—Allows you to select which source to
display. If the selected source is not available, the original
source will be displayed again. You may also cycle through
available sources by pressing the
Source button on the
projector or the remote control.
■ Factory Reset—Resets all previously saved user settings to
the original factory settings.
Special On-Screen Messages
Special on-screen messages will appear on the projection display
to identify the following conditions:
■ No Source Found. Please Check Signal Cable—Indicates
the video cable may not be plugged into the projector or the
selected video input is not accurate.
261794-001.book Page 9 Tuesday, January 22, 2002 2:20 PM