Compaq MP4800 - Manual (Page 14)

Using the Projector
Compaq iPAQ Microportable Projector MP4800 User’s Guide 2–3
Connecting the Projector to a Notebook
Computer
1. Connect one end of the projector signal cable into the side of
the projector and the other end to the DVI connector 1A or
the VGA connector 1B on the notebook computer and
tighten the screws.
✎
Be sure the signal cable aligns with the connector. Do not force
the cable onto the connector or you may damage the signal cable
or the projector.
2. Connect one end of the power cord 2 into the side of the
projector, and the other end to an electrical outlet that is
easily accessible and close to the projector.
261794-001.book Page 3 Tuesday, January 22, 2002 2:20 PM