Compaq iP-25E - Manual (Page 43)

E-43
1
Remove the lamp unit cover
Using a minus screwdriver, loosen the screws
of the lamp unit cover, pull in the direction of
the arrow, and remove the cover.
Maintenance
2
Loosen the mounting screws of the lamp unit
Using a minus screwdriver, loosen the 2 screws of
the lamp unit.
3
Pull out the lamp unit
Hold the handle of the lamp unit and pull it up and out.
4
Install a new lamp unit
ᕡ Take the lamp unit and press it into the projec-
tor.
ᕢ Check that the 2 positioning protrusions are firmly
inserted into the 2 holes.
ᕣ Tighten the 2 mounting screws of the lamp unit.
ᕤ Align the 2 tabs located on the lamp unit cover
with the projector and attach from the side of the
tabs. Tighten the mounting screws of the lamp
unit cover.
Lamp Unit Replacement Procedure
To prevent burns, wait one hour or longer after
the lamp has been switched off before perform-
ing the following procedure.
Positioning protrusions
Positioning protrusions