Century Jefferson - Manual (Page 23)

23
Jefferson Direct Vent /Natural Vent Gas Heater
30004177
3. Pull the top edge of the glass and frame assembly
away from the firebox and lift it off its supports on the
bottom of the firebox face. Place the assembly out of
the way on a flat, padded surface such as a counter
protected by a towel.
4. Take the logset out of the firebox if previously in-
stalled.
5. Remove the rear log bracket by unfastening the
screw. (Fig. 38)
6. Remove the right and left log bracket assembly by
unfastening the two screws that hold the burner in
place. (Fig. 38)
ST229a
FDV28 remove Front
12/8/99 djt
ST229a
Fig. 37 Remove stove front.
ST350
Jefferson
air shutter adj
3/20/00 djt
Remove Screws Rear Log Bracket
Pilot
Left & Right Log
Bracket Assembly ST350
Fig. 38 Remove rear log bracket and left and right log bracket
assembly.
7. Hold the burner at the right hand side and lift to clear
the right burner leg. Then pull to the right to clear the
injectors on the left hand side.
8. The air shutter is located on the bottom of the burner
to the left. (Fig. 39) Unfasten the two nuts holding
the shutter in place. The shutter may be adjusted
between the factory adjusted 1/2” to fully open.
Reassemble the shutter to allow the rear injector air
inlet to close from a minimum 1/2” opening to fully
open. (Fig. 40) You may have to try more than once
to find the correct air shutter opening for best results
depending on your altitude.
ST352
jefferson
air shutter
new position
3/20/00 djt
Air Shutter
(Original Position)
Burner See Table 1
ST352
Fig. 39 Air shutter in original from-the-factory position.
ST351
jefferson
air shutter
original position
3/20/00 djt
Front
Injector
Air Inlet Air Shutter
(May be adjusted up to fully open)
Burner
ST351
Rear Injector Air Inlet
Fig. 40 Air shutter adjusted.
9. Refasten the two nuts and assemble the burner into
the unit by sliding the burner in at an angle with the
left side lower than the right side. Slide the left side
onto the injectors. Lower the right hand side down
into place. Make sure the burner is as far left as pos-
sible and the injector shoulders are inside the burner.
NOTE: It is very critical to keep the left burner leg,
which holds the injectors at a 90° angle to the base.
(Fig. 41) This keeps the orifices aligned with tubes
on the inside of the burner. Failure to do so could
affect the flame appearance and performance of the
unit.
10. Refasten the right and left log bracket assembly.
11. Refasten the rear log bracket.
12. Replace logs.
13. Replace glass and stove front.
Follow lighting instructions on Page 26. Check flame
color appearance. NOTE: Allow stove to burn for at
least 1/2 hour to establish full flame color.
Should color need further adjustment, repeat Steps 1-
12 for further air shutter adjustment.