Casio PS-3000 - Manual (Page 18)

E-16
417A-E-018A
This section describes how to record keyboard play to
memory and playback data from memory.
About the Memory
Memory Capacity
Memory can hold up to 2,500 notes (one song).
• Recording stops automatically and the indicator above the
RECORD button goes out whenever memory becomes full.
Recorded Data
The following is a list of the data that can be recorded in
memory once recording starts.
• Anything you played on the keyboard (Received MIDI data
is not recorded.)
• Tone settings and any tone setting changes
• Beat setting used during recording
• Pedal operations
Recorded Data Storage
This piano has a lithium battery to supply power to retain
memory contents even while power is off.* The life of the
lithium battery is five years after the date of manufacture of
the piano. Be sure to contact your CASIO dealer about having
the lithium battery replaced every five years.
* Never turn off the digital piano power while a record
operation is in progress.
IMPORTANT!
• Recording new data to a song memory area
automatically deletes any data previously stored in that
song memory area.
• Turning off power while a record operation is in progress
deletes anything recorded up to that point.
• CASIO shall not be held responsible for any losses by
you or any third party due to loss of data caused by
malfunction or repair of this piano, or by battery
replacement.
Using the Memory
Recording
To record notes from the keyboard
PREPARATION
• Select the tone and effects you want to start with.
• If you want to use the metronome during recording, start
the metronome. Use the procedure under “Using the
Metronome” on page E-14 to set the beat and the tempo.
1
Press the RECORD button to put the piano into
record standby.
• The indicator above the RECORD button flashes.
• You can also change the metronome’s beat setting at
this time.
• If you want the metronome to sound while you are
recording, press the METRONOME button here to
start the metronome.
2
Play something on the keyboard to start recording.
• When you start recording, the indicator above the
RECORD button stops flashing and remains lit.
• What you play sounds from the speakers and is
recorded into memory.
• You can also start recording by pressing the START/
STOP button. In this case, blank space is inserted in
memory from the point that you press the START/
STOP button up to the point you start to play on the
keyboard.
3
After you are finished recording, press the START/
STOP button to stop the record operation.
• At this time the indicator above the RECORD button
goes out.
• To stop the metronome, press the METRONOME
button.
• Here you can press the START/STOP button and
playback the data you just recorded.
PS3000_e_16_20.p65 03.10.8, 2:22 PM 16