Casio PS-3000 - Manual (Page 15)

E-13
Basic Operations
417A-E-015A
To select a digital effect
1
While holding down the CONTROL button, press
the keyboard key that corresponds to the digital
effect you want to select.
• A note does not sound when you press a keyboard
key while holding down the CONTROL button.
Power on effect settings
The table below shows the effect settings that are assigned to
each tone whenever you turn on the digital piano power.
Tone Name
Digital Effect Setting
REVERB CHORUS
GRAND PIANO HALL 1 OFF
MELLOW PIANO HALL 1 OFF
GRAND PIANO 2 HALL 1 OFF
ELEC PIANO 1 HALL 1 ON
ELEC PIANO 2 HALL 1 ON
HARPSICHORD HALL 1 OFF
PIPE ORGAN HALL 1 OFF
STRINGS HALL 1 OFF
• The above digital effect settings can be changed after you
turn on power.
NOTE
• Selecting a tone automatically selects the digital effects
currently assigned to it.
• Changes you make to digital effect settings are assigned
to the currently selected tone only.
• Digital effect settings remain in effect until you turn off
the digital piano power.
• Demo tunes have their own digital effect settings, which
are automatically selected whenever you select a demo
tune.
More about tones
Polyphony
This piano can play up to 64 notes at the same time.
Also note that some of the tones offer only 32-note polyphony
(GRAND PIANO, MELLOW PIANO, ELEC PIANO 1,
HARPSICHORD, STRINGS).
Touch Response
The touch response feature of this piano causes the volume
of the tones and the sound of the tones themselves to change
slightly in accordance with how much pressure you apply to
the keyboard, just like with an acoustic piano. Touch response
affects the HARPSICHORD tone only slightly, because the
original musical instrument normally produces the same
sound, no matter how much pressure is applied.
Digitally Sampled Tones
The tones of this piano are produced using digitally recorded
samples of actual musical instruments. Not all of the
instruments, however, can produce tones across the entire
range played by this piano (A0 through C8). In such a case,
digital recordings are used for the range that actually can be
produced by the original instrument, and synthesized tones
are used for notes that cannot be produced naturally. Because
of this, you may notice very slight differences between natural
notes and synthesized notes in sound quality and in results
produced when using effects. These differences are normal
and do not indicate malfunction.
PS3000_e_08_15.p65 03.10.8, 2:22 PM 13