Citizen Systems CBM-290 User Manual
Page 44

CITIZEN
44
(39) Data Input Control (ESC = n)
Code : [1B]h + [3D]h + n
* {0
≤
n
≤
FF} Data is described in Hex code.
Selecting equipment in which data input from the host is effective.
l Each bit of n indicates as follows:
VALUE
BIT
EQUIPMENT
0
1
0
Printer
Invalid
Valid
1
Not defined
2
Not defined
3
Not defined
4
Not defined
5
Not defined
6
Not defined
7
Not defined
l When the printer has not been selected, this printer abandons all the received data until it
is selected by this command.
l Even when the printer has not been selected, it can become BUSY state through printer
operation.
l The initial value of n is "1".
(40) Aligning the characters (ESC a n)
Code : [1b}h + [61]h + n
* {0
≤
n
≤
2} Data is described in Hex code.
All the printed data within one line are aligned in the specified position.
l Depending on n value, positional alignment is carried out as in the table below:
n (Hex)
POSITION
0
Left end alignment
1
Centering
2
Right end alignment
l This is valid only when n is inputted at the beginning of line.
l The initial value of n is "0".