Citizen Systems CBM-290 - Manual (Page 20)

CITIZEN 20
3.5 Auto paper loading function
This printer equips a function to feed the paper automatically when a new paper for replacement
is inserted into paper inlet of printer mechanism.
This printer feeds paper automatically when the printer detects the paper in paper inlet.
3.6 Setting roll paper
1. Open the front cover.
2. Cut the edge of paper at a right or bent angle as the following drawing.
Insert the edge of paper into the paper inlet of the printer mechanism.
When paper is inserted into paper inlet in printer mechanism, paper is loaded automatically.
3. Make sure paper winding direction.
4. After setting paper, set roll paper inside of main unit.
5. Eliminating slack on the printing paper and close the front panel.
6. Feed paper by pressing Feed switch, if necessary.
*Factory setting is Head up position.
Make sure to pull head up lever forward to pull down printer mechanism, Because auto paper feed can not be
carried out at had up condition.
*When any print data is remaining us print buffer, printer stars printing automatically after loading paper.
Make sure to pay attention to the followings.
1. In case that the paper is bent or the paper is not fed properly, set print head at head up condition
and remove the paper carefully by turning paper feed knob.
2. For replacing roll paper, set print head at head up condition, and remove the paper which remains
in printer unit carefully by turning paper feed knob.