Harbor Freight Tools Chicago 91938 - Manual (Page 11)

Page 11 For technical questions, please call 1-800-444-3353. SKU 91938
SAFETY
OPERA
TION
MAINTENANCE
SETUP
General Operating Instructions
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.
Moving guards must move freely and close instantly. Bolt (112) MUST be loose before operation.
1. Using the vise, secure your workpiece and,
if necessary, adjust the angle of the cut.
2. Raise the Saw by pushing down on it
and pulling out the Lock Ball (25).
3. Plug the Power Cord into the nearest 120 V~,
grounded, electrical outlet. Slide the Trigger
Lock and pull the Trigger to start the Saw.
Allow the Cut-Off Wheel to attain full speed.
4. With one hand on the Handle and the other
hand clear, slowly bring the Saw down
onto the Base, letting the Saw do the work.
Do not apply excessive force.
5. If the Cut-Off Wheel does not cut all the way
through the workpiece, raise the Saw and release
the Trigger. Unplug the unit. Wait until the unit
comes to a full stop. Remove the workpiece.
Set the depth adjustment to a deeper setting.
After adjusting the depth, bring the Saw all the
way down to make sure the Cut-Off Wheel doesn’t
contact the Base. If it does contact any part of
the Base, re-adjust the depth so it doesn’t.
6. Repeat the cutting process starting
with number 1 above.
7. Once the cut is completed, turn off the Saw
by releasing the Trigger and unplug the unit.
Do not attempt to remove the workpiece until
the Cut-Off Wheel has stopped moving.
8. To prevent accidents, turn off the tool, disconnect
its power supply, and lock it down by pushing it
down as far as it will go, and then pushing the
Lock Ball (25) in after use. Clean, then store
the tool indoors out of children’s reach.