Harbor Freight Tools Chicago 91938 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. SKU 91938
SAFETY
OPERA
TION
MAINTENANCE
SETUP
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using the vise
to prevent movement while working:
a. To use the Quick Release (31), put the Quick
Release (31) tab in the position shown in
Figure E and push the Vise Handle (28)
up against the workpiece. Then tighten the
Vise Handle (28). When releasing, loosen the
Vise Handle (28) a few turns, lift up the Quick
Release (31), and pull the Vise Handle (28) open.
Figure E: Vise Components
Vise Handle (28)
Place Workpiece Here
Quick
Release (31)
b. To cut at various angles (up to 45º),
adjust the Angle Scale (35) by loosening the
two Bolts (41 & 44) as shown in Figure F.
Adjust the Angle Scale to the desired setting
and then tighten the Bolts (41 & 44).
Figure F: Angle Scale
Bolts (41 & 44)
Angle
Scale
(35)
Upper Two Screw Holes
c. To reposition the Angle Scale (35), remove both of
the Bolts (41 & 44), and reattach the Angle Scale
at the upper two screw holes. See Figure E.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.