beautypg.com

Installing the cable-management arm – Dell POWEREDGE 2950 User Manual

Page 19

background image

Rack Installation Guide

17

4 Pull the system out of the rack until it stops because of the safety catch.
5 Pull up on the front release latch on each rail to disengage the safety catch (see Figure 1-7) and slide

the system forward.

6 Pull the system completely out of the rack.

Installing the Cable-Management Arm

NOTE:

You can attach the cable-management arm to either side of the rack cabinet.

NOTE:

Attach the cable-management arm ramp assembly to the side opposite of where you attach the cable-

management arm.

1 Fit the latch on the front end of the cable-management arm onto the bracket on the end of the

mounting rail until the latch clicks (see Figure 1-8).

2 Fit the latch on the unattached end of the cable-management arm onto the bracket on the end of the

slide assembly until the latch clicks (see Figure 1-8).

CAUTION:

Both ends of the cable-management arm must be connected before you begin routing the system

cables

.

Figure 1-8.

Installing the Cable-Management Arm

1

mounting rails (2)

2

brackets (2)

3

latches (2)

4

cable-management arm

back of system

1

2

4

3