CITIZEN CT-S310II - Manual (Page 40)

— 37 —
Note:
*: EPSON is a registered trademark of Seiko Epson Corporation.
Individual setting mode
Set the memory switches individually.
Do the settings while confirming the memory switch function and settings on
the printout.
1. Load paper.
2. While the paper cover is open, press and hold the FEED button while turning the
power on.
3. Press the FEED button twice and close the paper cover.
The printer enters the mode for setting memory switches individually.
The printer prints “Memory SW (1)” and the current setting, 0 (off) or 1 (on).
(The current settings for memory switches 7 to 10 are not printed.)
4. Press the FEED button.
The list of memory switches cycles through in order from “Memory SW (1)”
→
“Memory SW (2)”
→ ... “Memory SW (10)” → “Save To Memory” → “Memory SW
(1)”
→ each time the FEED button is pressed.
Press the FEED button until the number for the memory switch you want to change is
printed.
Selected item Automatic memory switch settings
Model
Paper
width
Character
space
MSW2-4
Full Col
Print
MSW3-7
CBM1000
Mode
MSW8-1
Print
Width
MSW6-2
Character
Space
CITIZEN CT-S310 58 mm — WaitData Invalid 384 dots —
80 mm — WaitData Invalid 576 dots —
EPSON T88* 58 mm Invalid WaitData Invalid 360 dots 0 dot
Valid WaitData Invalid 390 dots 1 dot
80 mm Invalid WaitData Invalid 512 dots 0 dot
Valid WaitData Invalid 546 dots 1 dot
EPSON 203dpi* 58 mm — WaitData Invalid 420 dots —
80 mm — WaitData Invalid 576 dots 0 dot
Current memory switch
Current setting