Canon RS-CL07 - Manual (Page 25)

Replacing the Lamp and Cleaning/Replacing the Air Filter
This Ceiling-mount Hanger allows you to replace the lamp and clean/replace the air filter without dismounting the
projector.
1 Hold the projector, and remove two wing
screws (A) and open the Base bracket
slowly.
2 Replace the lamp, or clean or replace the
air filter.
3 After completion of replacement of the
lamp or cleaning/replacement of the air
filter, lift up the projector, and close the
Base bracket then tighten the wing screw
(A).
Lamp cover
Filter cover
RS-CL10
Lamp cover
Filter cover
RS-CL07
RS-CL07 RS-CL10
Adjustment
rangee
Horizontal projection angle 5° leftward or rightward 5° leftward or rightward
Vertical projection angle 5° upward or 20° downward 5° upward or 20° downward
Screen slant angle ± 5 ° ± 5 °
Outer dimension of assembly
(excluding projection)
222.7 mm (W）x 281.5 mm (D）x 175.8 mm (H)
0.7' (W) x 0.9' (D) x 0.6' (H)
310.5 mm (W) x 276.2 mm (D) x 178.2 mm (H)
1.0' (W) x 0.9' (D) x 0.6' (H)
Weight (Ceiling-mount Hanger only) 3.7 kg/8.2 lbs 4.1 kg/9.1 lbs
Specifications
● Before replacing the lamp or cleaning/replacing the air filter, be sure to turn off the projector and
unplug the power cord from the AC outlet and that the projector is cooled sufficiently.
● For details on how to replace the lamp and clean/replace the air filter, refer to the User's Manual
that came with the projector.
● Check the projection angle and the screen slant angle after replacing the lamp. For details on how
to adjust the angles, refer to page 11.
Caution
A A
A A
1
1