Dell PowerEdge 750 - Manual (Page 2)

www
.dell.com | support.dell.com
c Locate the P4 power cable connector.
The P4 connector is part of a cable assembly that connects the power supply to both hard
drives and the CD drive’s interposer card.
d Connect the P4 power cable connector to the CD drive’s interposer card.
Figure 1. Removing and Installing the Optional CD Drive
11 Place the cover over the sides of the chassis, and slide the cover forward until it snaps
into place.
12 Tighten the two captive screws at the back of the system to secure the cover.
13 Reconnect the system to the electrical outlet, and turn on the system.
14 If applicable, replace the bezel.
a Align the hole in the left-side bezel securing tab with the tab on the front panel.
b While rotating the bezel toward the front panel, slide the bezel toward the key lock
until the bezel snaps into place.
retaining pins (4)
bracket release lever
fasteners (2)
hard drive 0
interposer board
interface cable
mounting holes (4)
C3740am0.fm Page 2 Tuesday, December 16, 2003 5:31 PM