LaserMax LMS-UNI-MAX GREEN - Manual

For: UNI–RED, UNI–GREEN, and UNI–IR
Installing the Laser System
Changing the Batteries
Installation Guide
What’s in the Box
A Laser Housing
B Battery Cover
C Clamping Screw
D Phillips Head Screws
E Batteries 357 (2) or 1/3N (2)
F Adjustment Tool
G Activation Switch
1 | Remove the magazine from your
firearm and clear the chamber.
Check if your gun is unloaded.
2 | Check again!
3 | Slightly loosen the clamping
screw on the laser housing
to open the rail grips.
DO NOT REMOVE CLAMPING
SCREW. Mount the laser on the
rail of your firearm, making sure
the rail grips on the laser unit are
firmly set into the grooves on the
rail and the clamping screw is in
line with the notch in your rail
(figure A).
4 | Tighten the clamping screw with
the fingers to ensure a secure
fit (figure B). Further tighten the
clamping screw with a
screwdriver or coin until the laser
is firmly attached (figure C).
5 | Turn on the laser by pressing in
on the activation switch from the
right or left side. The center
position is off.
6 | Follow the manufacturer’s
instructions to attach your choice
of additional accessories onto
the Integrated Picatinny Rail
(figure D).
1 | Unscrew and remove
both phillips head screws from
battery cover.
2 | Remove battery cover from laser
housing and insert batteries into
unit as shown.
3 | Put battery cover back in place
on laser housing, making sure
the lip on the cover first engages
the slot in the laser housing.
4 | Install and tighten both Phillips
head screws into battery cover.
Do not overtighten.
TIMEOUT!
To avoid unintentional
battery drain, the laser is set
to automatically turn off after
10 minutes. When timed out,
simply cycle the activation
switch to refresh the laser and
turn it back on!
Spare Parts List
LMS–UNI–RG Removable rail grip
LMS–UNI–CS Clamping screw
LMS–UNI–AS Activation switch
LMS–2X357 or LMS–2X13N Batteries: 357 (2) or 1/3N (2)
LMS–AT50 Adjustment tool
A
C
G
F
E
D
B
Accessories
LMS–UNI–MAS–6 Momentary Activation Switch 6” cord
LMS–UNI–MAS–10 Momentary Activation Switch 10” cord
LMS–ADP–SIGMA Rail adapter for S&W Sigma series
LMS–ADP–SHOTGUN Rail adapter for 1” shotgun mag tube
LMS–HKADP–C Rail adapter for H&K USP compact
LMS–HKADP–F Rail adapter for H&K USP full size
LMS–ADP–AR Rail adapter for Black Rifles
A
B
C
D
E
F
Changing the Laser Mode
Turn the laser on for at least two seconds, then turn it off. Next,
turn the laser on and off three times from the same side while
stopping at the center position while turning off (each on/off cycle
should take less than half of a second).When the laser is turned on,
the mode will have changed. To return the laser to the previous
mode, repeat the process.
01785-0-51
Disclaimer
Export of LaserMax IR Lasers is strictly prohibited without a valid export license
issued by the U.S. Department of State Office of Defense Trade Controls, in
accordance with International Traffic in Arms (ITAR), Title 22, Code of Federal
Regulations Part 120-130. Transfer to a foreign person is considered
an export even if done within the US. For further information contact
the Office of Defense Trade Control @ (202) 663-1282 .