Baumer VisiLine cameras User Manual
Page 2
LED Signaling
1
2
LED
Signal
Meaning
1
green
Link active
green flash
Receiving
2
yellow
Transmitting
Installation
Installation of the camera:
Connect the camera using an
▪
appropriate cable (at least Cat-5e)
to he GigE board on your PC.
If required, connect a trig-
▪
ger and / or flash to process
interface.
Connect the camera to power supply.
▪
Installation of cameras with PoE:
Connect the camera using an appropriate cable (at least Cat-5e) to a free port of a
▪
PoE capable ethernet switch.
Establish the connection between switch and GigE board on your PC.
▪
If required, connect a trigger and or flash to process interface.
▪
Data Interface / Power Supply / Digital IOs
Notice
The VisiLine supports PoE (Power over Ethernet) IEEE 802.3af Clause 33, 48 V
power supply.
8P8C mod jack with LEDs
1
8
1
green/white
MX1+
(negative / positive V
port
)
2
green
MX1-
(negative / positive V
port
)
3
orange/white
MX2+
(positive / negative V
port
)
4
blue
MX3+
5
blue/white
MX3-
6
orange
MX2-
(positive / negative V
port
)
7
brown/white
MX4+
8
brown
MX4-
Power supply / Digital-IO
wire colors of the connecting cable
1
4
5
6
3
2
3
4
1
1
Power V
CC
brown
1
not used
brown
2
IN 1
white
3
OUT 2
blue
3
GND
blue
4
OUT 3
black
4
OUT 1
black
Notice
The electrical data are available in he
respective data sheet.
5
U
ext
OUT
grey
6
GND IN
pink
Installation sample
1 - PCI board; 2 - GigE cable;
3 - Power cable / Digital-IO; 4 - Digital-IO
Installation sample
1 - PCI board;
2 - GigE cable;
3 - PoE capable ethernet switch
or Baumer PoE components;
4 - Cable for trigger and flash
open wire
Heat Transmission
Caution
Heat can damage the camera. Provide adequate dissipation of heat,
to ensure that the temperature does not exceed
he value in the table
below.
As there are numerous possibilities for installation, Baumer does not
specify a specific method for proper heat dissipation.
T
Measure Point
Maximal Temperature
T
50°C (122°F)
General Description
1
2
3
4
No.
Description
No.
Description
1
C-Mount lens connection
4
Power supply / Digital-IO
2
Ethernet Port
3
Digital-IO
open wire