Citizen Systems iDP3423 - Manual (Page 35)

iDP3420/3421/3423 User’s Manual
19 CITIZEN
4.12 Operation Panel and Display of Error
1. POWER lamp (Green)
This lamp is illuminated when the power is supplied.
2. ERROR lamp (Red)
This lamp is illuminated or blinks to indicate each error.
Error Indication ERROR Lamp Buzzer Resetting Method
Mechanical Error Quick blinking Sounds continuously for
approx. 1 second Reset the Power
switch.
Paper End Illuminated Repeats a short 3-time
sound twice at intervals of
0.5 second. Set a new paper roll.
Paper Near End Blinks
(Once a second)
Repeats a short 3-time
sound twice at intervals of
0.5 second. Set a new paper roll.
Cutter Motor Lock
(iDP3421/23 only)
Quick blinking
(Twice a second)
Sounds continuously for
approx. 1 second. Eliminate a paper jam.
Mechanical Error : If the printer mechanism has a greater load due to a paper jam, etc., the buzzer
will sound and the ERROR lamp will blink to stop the printer mechanism.
Paper End : If the paper has run out, the paper sensor in the paper path near the print head
will detect the end of the paper roll, turn on the buzzer, and illuminate the
ERROR lamp to stop the printer mechanism.
If the paper is inserted into the
paper path, the paper roll will be loaded. (See 4.7 Inserting the Paper)
Paper Near End : If the paper is running out, the paper near end sensor will be activated to turn on
the buzzer and make the ERROR lamp blink. Even after the paper near end is
detected, a command can be used to print by the specified number of lines. (See
a description on the command for setting the number of print lines after paper
near end detection)
Cutter Motor Lock : If the cutter position detection sensor in the cutter unit is left turned on or off
for approx. 1 second while the cutter motor is running, cutter operation and
printing will be suspended, determining it to be motor lock.
3. FEED switch
If this switch is pressed once for a short time, the paper will be fed
by 1 line. If it is held down, the paper will be fed continuously.
4. FEED switch and Power switch
When the power is turned on, the printer follows the operation flow
at "power-on" on the next page, depending on how the FEED switch
is operated.
POWER Lamp
ERROR Lamp
FEED Switch
(iDP3421/23 only)