Vermont Casting A052041 User Manual
Page 16
17
ATTENTION PRODUCT ASSEMBLER:
Install the X-brace retainer wire across the back of the pillar for warranty validation.
3. Position the wire ends “A” and “B” firmly into the pillar
corners behind the bolt heads and against the base.
(See Lower Detail.)
4. Complete the installation by snapping bent ends “C”
and “D” into the two holes in the pillar. (See Upper
Detail.)
5. When complete, the X-brace should be positioned as
shown in the lower right picture.
back
UPPER
DETAIL
LOWER
DETAIL