Vermont Casting A052041 - Manual (Page 13)

1. Lock the pre-assembled casters on
base by pushing down on the latch.
2. Set the base upside-down on onto
the pillar bottom as shown on the
adjacent page, aligning holes in
base with holes in pillar.
3. Insert six bolts through the holes in
the pillar and base. Thread the
locking hex nuts onto bolts.
Tighten with a wrench and a flat-
head screwdriver.
4. Locate the two black lead wires
inside the grill bottom. Press the
metal contacts of the loose ends of
the lead wires onto the metal pins
located on the base and side of the
ignitor unit.
14
base
( 1 )
shown
right-
side up
Assembly Instructions • Assemble Base to Pillar
1/4-20 x 3/4”
( 6 )
Use hardware bag “A”:
Locate this part:
1/4-20
( 6 )
front
locking
casters
tools needed:
3 ⁄
8
" open-end wrench
7 ⁄
16
" open-end wrench
top
back
assembled
pillar
and
bottom
casting
back