beautypg.com

Dodge 2015 Journey - User Guide User Manual

Page 99

background image

3. Place the jack underneath the lift area that is closest to the flat tire. Turn the jack screw

clockwise to firmly engage the jack saddle with the lift area of the sill flange.

4. Raise the vehicle by turning the jack screw

clockwise with the jack handle. Raise the
vehicle until the tire just clears the road
surface and enough clearance is obtained
to install the spare tire. Minimum tire lift
provides maximum stability.

5. Remove the wheel nuts. For vehicles so

equipped, remove the wheel cover from
the wheel by hand. Do not pry the wheel
cover off. Then pull the wheel off the
hub.

6. Install the spare tire.

NOTE:

For vehicles so equipped, do not attempt to
install a center cap or wheel cover on the
compact spare.
7. Install the wheel nuts with the cone-

shaped end of the nut toward the wheel.
Lightly tighten the wheel nuts.

8. Lower the vehicle by turning the jack

screw counterclockwise with the jack
handle.

9. Finish tightening the lug nuts. Push

down on the wrench while at the end of
the handle for increased leverage.
Tighten the lug nuts in a star pattern
until each nut has been tightened twice.
The correct tightness of each lug nut is
100 ft.lbs. (135 N·m). If in doubt about
the correct tightness, have them
checked with a torque wrench by you
authorized dealer or service station.

10. Lower the jack to its fully closed position.
11. Place the deflated (flat) tire in the

cargo area.

Do not stow the deflated

tire in the spare tire stowage location.

Have the deflated (flat) tire repaired or
replaced as soon as possible.

Front Jacking Location

Rear Jacking Location

Installing Compact Spare

W H AT T O D O I N E M E R G E N C I E S

97