Jump-starting procedure – Dodge 2015 Journey - User Guide User Manual
Page 104
Jump-Starting Procedure
1. Connect the positive
(+)
end of the jumper cable to the remote positive
(+)
post of the
vehicle with discharged battery.
2. Connect the opposite end of the positive
(+)
jumper cable to the positive
(+)
post of the
booster battery.
3. Connect the negative
(-)
end of the jumper cable to the negative
(-)
post of the booster
battery.
4. Connect the opposite end of the negative
(-)
jumper cable to the remote negative
(-)
post of the vehicle with the discharged battery.
5. Start the engine in the vehicle that has the booster battery, let the engine idle a few
minutes, and then start the engine in the vehicle with the discharged battery.
Once the engine is started, remove the jumper cables in the reverse sequence:
1. Disconnect the negative
(-)
end of the jumper cable from the remote negative
(-)
post
of the vehicle with the discharged battery.
2. Disconnect the opposite end of the negative
(-)
jumper cable from the negative
(-)
post
of the booster battery.
3. Disconnect the positive
(+)
end of the jumper cable from the positive
(+)
post of the
booster battery.
4. Disconnect the opposite end of the positive
(+)
jumper cable from the remote positive
(+)
post of the discharged vehicle.
5. Reinstall the protective cover over the remote positive
(+)
post of the vehicle with the
discharged battery.
6. Reinstall the protective plug over the remote negative
(-)
post of the vehicle with the
discharged battery.
NOTE:
If frequent jump-starting is required to start your vehicle you should have the battery and
charging system inspected at your authorized dealer.
W H AT T O D O I N E M E R G E N C I E S
102