Dodge 2015 Journey - User Guide - Manual (Page 80)

Uconnect® 8.4 Customer Programmable Features
• The Uconnect ® 8.4 system allows you to access Customer Programmable feature
settings such as Display, Clock, Safety/Assistance, Lights, Doors & Locks, Heated
Seats, Engine Off Operation, Compass Settings, Audio, Phone/Bluetooth
® and SIRIUS
Setup through buttons on the touchscreen.
• Press the “More” button on the bottom of the touchscreen, then press the “Settings”
button on the faceplate to access the Settings screen. When making a selection, scroll
up or down until the preferred setting is highlighted, then press and release the
preferred setting until a check-mark appears next to the setting, showing that setting
has been selected. The following feature settings are available:
• Display • Auto On Comfort & Remote Start
• Clock • Engine Off Options
• Safety/Assistance • Audio
• Lights • Phone/Bluetooth ®
• Doors & Locks • SIRIUS Setup
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink ® replaces up to three hand-held transmitters that operate devices such as
garage door openers, motorized gates, lighting or home security systems. The
HomeLink
® unit is powered by your vehicles 12 Volt battery.
• The HomeLink ® buttons that are located in the overhead console or sunvisor designate
the three different HomeLink ® channels.
• The HomeLink ® indicator is located above the center button.
Before You Begin Programming
HomeLink®
Ensure that your vehicle is parked outside
of the garage before you begin program-
ming.
For efficient programming and accurate
transmission of the radio-frequency signal,
it is recommended that a new battery be
placed in the hand-held transmitter of the
device that is being programmed to the
HomeLink
® system.
To erase the channels, place the ignition
switch into the ON/RUN position, then
push and hold the two outside HomeLink
®
buttons (I and III) for up to 20 seconds or
until the red indicator flashes.
Universal Garage Door Opener (HomeLink®)
Buttons
E L E C T R O N I C S
78