beautypg.com

Dodge 2015 Dart - Owner Manual User Manual

Page 285

background image

2. Place the hand-held transmitter 1 to 3 inches (3 to 8

cm) away from the HomeLink® button you would like

to program while keeping the HomeLink® indicator

light in view.

3. Simultaneously push and hold both the HomeLink®

button you want to program and the hand-held trans-

mitter button.

4. Continue to hold both buttons and observe the indi-

cator light. HomeLink® indicator will flash slowly

and then rapidly after HomeLink® has received the

frequency signal from the hand-held transmitter. Re-

lease both buttons after the indicator light changes

from slow to rapid.

5. Push and hold the programmed HomeLink® button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should

activate when the HomeLink® button is pressed.

• To program the remaining two HomeLink® buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

Reprogramming A Single HomeLink® Button
(Non — Rolling Code)
To reprogram a channel that has been previously trained,

follow these steps:
1. Cycle the ignition to the ON/RUN position.
For vehicle’s equipped with Keyless Enter-N-Go™, place

the ignition in the RUN position with the Engine ON.
2. Push and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do

not release the button.

3. Without releasing the button proceed with “Program-

ming A Non-Rolling Code” step 2 and follow all

remaining steps.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 283