beautypg.com

Before you begin programming homelink, Programming a rolling code – Dodge 2015 Dart - Owner Manual User Manual

Page 282

background image

Before You Begin Programming HomeLink®

Be sure that your vehicle is parked outside of the garage

before you begin programming.
For more efficient programming and accurate transmis-

sion of the radio-frequency signal it is recommended that

a new battery be placed in the hand-held transmitter of

the device that is being programmed to the HomeLink®

system.
To erase the channels place the ignition in the ON/RUN

position and push and hold the two outside HomeLink®

buttons (I and III) for up 20 seconds or until the red

indicator flashes.

NOTE:

• Erasing all channels should only be performed when

programming HomeLink® for the first time. Do not

erase channels when programming additional buttons.

• If you have any problems, or require assistance, please

call toll-free 1-800-355-3515 or, on the Internet at

HomeLink.com for information or assistance.

Programming A Rolling Code

For programming garage door openers that were manu-

factured after 1995. These garage door openers can be

identified by the “LEARN” or “TRAIN” button located

where the hanging antenna is attached to the garage door

opener. It is NOT the button that is normally used to

open and close the door. The name and color of the

button may vary by manufacturer.

280 UNDERSTANDING THE FEATURES OF YOUR VEHICLE