beautypg.com

Programming a non-rolling code – Dodge 2015 Dart - Owner Manual User Manual

Page 284

background image

Firmly push and release the “LEARN” or “TRAIN-

ING” button. On some garage door openers/devices

there may be a light that blinks when the garage door

opener/device is in the LEARN/TRAIN mode.

NOTE:

You have 30 seconds in which to initiate the next

step after the LEARN button has been pushed.
6. Return to the vehicle and push the programmed

HomeLink® button twice (holding the button for two

seconds each time). If the garage door opener/device

activates, programming is complete.

NOTE:

If the garage door opener/device does not acti-

vate, push the button a third time (for two seconds) to

complete the training.
To program the remaining two HomeLink® buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

Reprogramming A Single HomeLink® Button
(Rolling Code)
To reprogram a channel that has been previously trained,

follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do

not release the button.

3. Without releasing the button proceed with “Program-

ming A Rolling Code” step 2 and follow all remaining

steps.

Programming A Non-Rolling Code

For programming Garage Door Openers manufactured

before 1995.
1. Cycle the ignition to the ON/RUN position.

282 UNDERSTANDING THE FEATURES OF YOUR VEHICLE