beautypg.com

Dodge 2014 Journey - Owner Manual User Manual

Page 579

background image

7. Wipe the dipstick clean and reinsert it until seated.

Then, remove the dipstick and note the fluid level on
both sides. The fluid level reading is only valid if there
is a solid coating of oil on both sides of the dipstick.
Note that the holes in the dipstick will be full of fluid
if the actual level is at or above the hole.

• If the fluid is hot, the fluid level should be in the

crosshatched area marked “HOT” (between the up-
per two holes in the dipstick).

• If the fluid is cold, the fluid level should be between

the lower two holes in the area marked “COLD.”

If the fluid level is low, add fluid through the dipstick
tube to bring it to the proper level. Do not overfill. After
adding any quantity of oil through the dipstick tube, wait
at least two minutes for the oil to fully drain into the
transmission before rechecking the fluid level.

NOTE:

If it is necessary to check the transmission below

the operating temperature, the fluid level should be
between the two COLD (lower) holes on the dipstick
with the fluid at approximately 80°F (27°C). If the fluid
level is correctly established at 80°F (27°C), it should be
between the HOT (upper) reference holes when the
transmission reaches 180°F (82°C). Remember it is best to
check the level at the normal operating temperature.

8. Check for leaks. Release the parking brake.

CAUTION!

Using a transmission fluid other than the manufactur-

er’s recommended fluid may cause deterioration in
transmission shift quality and/or torque converter
shudder, and will require more frequent fluid and
filter changes. Refer to “Fluids, Lubricants, and Genu-
ine Parts” in this section for fluid specifications.

(Continued)

7

MAINTAINING YOUR VEHICLE

577