beautypg.com

Emissions inspection and maintenance programs, Emissions inspection and, Maintenance programs – Dodge 2013 Journey - Owner Manual User Manual

Page 530

background image

is heard and press the TRIP ODOMETER button to turn
off the message. If the problem persists, the message will
appear the next time the vehicle is started.

A loose, improperly installed, or damaged fuel filler cap
may also turn on the MIL.

EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS

In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.

For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not

on when the engine is running, and that the OBD II
system is ready for testing.

Normally, the OBD II system will be ready. The OBD II
system may not be ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.

Your vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD II system is ready, you must
do the following:

1. Turn the ignition switch to the ON position, but do not

crank or start the engine.

2. If you crank or start the engine, you will have to start

this test over.

3. As soon as you turn the ignition switch to the ON

position, you will see the MIL symbol come on as part
of a normal bulb check.

528

MAINTAINING YOUR VEHICLE