beautypg.com

Reprogramming a single homelink® button – Dodge 2013 Journey - Owner Manual User Manual

Page 258

background image

4. Watch for the HomeLink® indicator to change flash

rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.

5. Press and hold the programmed HomeLink® button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should
activate when the HomeLink® button is pressed.

• To program the two remaining HomeLink® buttons,

repeat each step for each remaining button. DO NOT
erase the channels.

If you unplugged the garage door opener/device for
programming, plug it back in at this time.

Reprogramming A Single HomeLink® Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Cycle the ignition to the ON/RUN position.

2. Press and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do
not release the button.

3. Without releasing the button proceed with “Canadian/

Gate Operator Programming” Step 2 and follow all
remaining steps.

256

UNDERSTANDING THE FEATURES OF YOUR VEHICLE