NISSAN 2015 Rogue - Owner's Manual - Manual (Page 412)

Use the following steps to mount the front license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag:
● License plate bracket
● License plate bracket (J-nut) screws x 2
● License plate screws x 2
● Screw grommets x 2
1. Park the vehicle on flat, level ground.
2. Locate the center position
᭺
A as illustrated.
Line up the license plate bracket under the
top of the front bumper
᭺
B with the tabs
᭺
C .
Hold the license plate bracket in place.
3. Mark the center of the hole
᭺
D with a felt-tip
pen.
4. Carefully drill two pilot holes using a 0.39 in
(10 mm) drill bit at the marked locations. (Be
sure that the drill only goes through the
bumper fascia.)
5. Insert the grommets into the holes in the
bumper fascia.
6. Insert a small flat-bladed screwdriver into
the grommet hole to turn the threaded part of
the grommet 90°
᭺
E .
LTI2039
INSTALLING FRONT LICENSE PLATE
Technical and consumer information 9-13