NISSAN 2013 Quest - Owner's Manual - Manual (Page 235)

Black plate (231,1)
[ Edit: 2013/ 3/ 26 Model: E52-D ]
Rear air conditioning system
To control the rear air conditioning system
independently with the front air conditioner
control panel, push the “REAR” button. When
the rear air conditioning system control is on, the
indicator light on the “REAR” button will
illuminate and “
” will appear on the display.
In this state, the rear air conditioning system can
be adjusted with the front air conditioner control
panel. However, if no operation is conducted for
approximately 10 seconds after the “REAR”
button is pushed, the front air conditioner
control panel will automatically switch to the
front air conditioning mode.
To cancel the rear air conditioning mode and
switch back to the front air conditioning mode,
push “REAR” button one more time.
Automatic operation:
1. Push the “REAR” button to display “
” on
the front display when the rear air condition-
ing system is on.
2. Push the “AUTO” button. (The AUTO
indicator light will illuminate.)
3. Push the temperature control buttons
(“ ” and “ ”) (driver’s side) to set the
desired temperature.
Manual operation:
To operate the rear air conditioning system using
the front air conditioner control panel, push
“REAR” button (the indicator light on the
“REAR” button will illuminate and “
” will
appear on the display).
. Temperature control
Push the temperature control buttons
(“
” and “ ”) (driver’s side) to set the
desired temperature.
. Fan speed control
Push the fan speed control “
”
button or “ ” button to manually
control the fan speed.
. Air flow control
Push the “MODE” button to change the air
flow mode.
: The air outlet is fixed at foot level.
: The air outlet is fixed at both the head and
foot level.
: The air outlet is fixed at the head level.
NOTE:
Pushing the “A/C” button when the rear air
conditioning system is turned on and
“
” does not appear on the display will
turn off the rear air conditioning system
(except when the air flow is set to the
position).
Rear Heating (A/C off):
1. Push the “REAR” button to display “
” on
the front display when the rear air condition-
ing system is on.
2. Switch the air flow mode to by pressing
the “MODE” button.
3. Push the “AUTO” button. (The AUTO
indicator light will illuminate.)
4. If the A/C indicator light illuminates, push the
“A/C” button. (The A/C indicator light will
turn off.)
5. Push the temperature control buttons
(“ ” and “ ”) (driver’s side) to set the
desired temperature.
. Do not set the temperature lower than the
outside air temperature. Doing so may cause
the temperature to not be controlled prop-
erly.
. To dehumidify the air, push the “A/C” button
before turning on the heater.
. Air does not blow out from the vents on the
ceiling when the system is used for heating.
Turning the system off:
To turn off the rear air conditioner, push the
“ON·OFF” button when “
” is on the display.
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-51
Condition: