NISSAN 2013 Quest - Owner's Manual - Manual (Page 121)

Black plate (117,1)
[ Edit: 2013/ 3/ 26 Model: E52-D ]
SIC2770
The seats are warmed by built-in heaters. The
switches located on the instrument panel can be
operated independently of each other.
1. Start the engine.
2. Select heat range.
*
1 For high heat, push the HI (High) side of
the switch.
*
2 For low heat, push the LO (Low) side of
the switch.
The indicator light in the switch *
3 will
illuminate when the heater is on.
3. To turn off the heater, return the switch to
the level position. Make sure the indicator
light goes off.
The heater is controlled by a thermostat,
automatically turning the heater on and off.
The indicator light will remain on as long as
the switch is on.
When the vehicle’s interior is warmed, or
before you leave the vehicle, be sure to turn
off the switch.
SSD1179
The Blind Spot Warning (BSW) switch will turn
on and off the Blind Spot Warning (BSW)
system.
The BSW system will illuminate the Blind Spot
Warning (BSW) indicator lights, in the outside
mirrors, when the radar sensors detect a vehicle
in the detection zone. If the turn signal is
activated in the direction of the detected vehicle,
a chime sounds twice and the BSW indicator
light will flash. (See “Blind Spot Warning (BSW)
system” (P.5-17).)
The BSW switch is automatically turned on
when the engine is started, and the BSW ON
indicator
*
1 on the switch illuminates.
To cancel the warning systems, push the BSW
Instruments and controls 2-39
BLIND SPOT WARNING (BSW)
SWITCH (if so equipped)
Condition: